AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Networx alarms every 24 hours11/10/2022 Note that if your power (AC FAIL) or phone service is out (sometimes the cause for COMM FAIL), there isn't anything for us to do- the trouble will clear when the service returns and the system sends a signal to the central station. Batteries in wireless motion detectors or door switches may need replacement as often as 1-3 years. The main panel battery will recharge within 48 hours unless it is getting too old (usually 5+years). If it tells you you have a low battery, call on the next business day to see about having it replaced. then hit # to return to the regular display. If you have an LCD screen, use the right arrow button to scroll through and read all of the trouble signals. If you have had recent work done on your phones, or changed phone providers, that may be the cause. Your system may have tried to send a test signal and it failed, or it may have detected a loss of your landline dial tone. Telco fail/ Communication failure/ loss of connection. #Networx alarms every 24 hours plus#Panel batteries are only $35 plus tax from us, installed if you are a monitored customer. If the battery does not recharge within 2 days, remember to call us to get your battery changed. You can still operate your system normally after clearing the trouble by viewing (* then 2) or resetting it by holding down 9 on the Napco MA. This is a condition to be aware of, but not an emergency. The battery may recharge in a day or two. Low battery: The battery power is decreasing (not dead). The system will operate for hours, sometimes days, on its back-up battery. If ANY GFI in the building trips and your alarm happens to be plugged into another GFI on the same circuit it could cause the A/C fail indicator to show up. *(GFIs/ ground fault interrupt outlets are installed commonly in basements, bathrooms and kitchens. You only have to disconnect one wire to the battery to kill it. To do this you have to unplug the transformer AND open the alarm panel box and disconnect the battery. If that won't work, you may want to disconnect power to the system. If you can't restore the power, you'll want to silence the trouble and wait for the power to be fixed. If not, try running an extension cord to power the system transformer temporarily until the outlet gets fixed. If it is and none of the circuits are bad or GFIs* are tripped you can see if another appliance will work in that outlet. Flip circuits that are tripped or replace fuse as needed.Ĭheck GFI outlets and reset them with button in the middle marked reset.įind the system's transformer and make sure it is plugged in. You need to restore power to the system if possible.Ĭheck the circuit breaker/fuse box. If you don't hear back promptly, call again in case there has been a failure of the paging system.Ī/C fail: This means that your system isn't getting power from its normal source, a power outlet. A technician will call back within 15 minutes. Call our on-call service technician for help with emergencies at 81 after hours. To speak with a technician: call our office at 81 x2 on weekdays. You can read more about these trouble conditions and what to do about them below. DSC: hold down reset or view trouble on DSC by pressing * then 2. Then, to silence beeping (trouble signal): Honeywell: press any key. #Networx alarms every 24 hours how to#Here's how to deal with these "trouble" signals.īEEPING: MAKE A NOTE OF ANY WORDS OR NUMBERS SHOWING UP. It is annoying, but it is necessary that you know what is going on. In all of these cases, the alarm system will notify you of the problem by beeping and flashing lights. If your system is "acting up" read on: Most emergency service calls are due to phone line, battery or power interruptions. IF YOUR ALARM IS BEEPING OR FLASHING LIGHTS YOU HAVE FOUND THE RIGHT PAGE
0 Comments
Read More
Leave a Reply. |